Latex mold--the first fitting and evaluation
Okay, first thing I did today was pulling out my mold to see what needed to be done. Sadly, some of the wigglies were uneven and not fully round so I had to cut and trim parts of it. Then I had to make layer after layer of latex to make a rounded wiggly. This is BEFORE I did that. You can see the wiggly in back looks chewed and unfinished. I'm holding my cap to my neck since the neck ended up being too wide and I'll have to trim down that area.
Copyright 2002-2013 Cosplay.com, LLC. All Rights Reserved.
All comments and posts in our forums are the opinion of the respective poster.