Step 39 - Boarders (Back Side)
To finish off the back side, we're going to run more gold trim down the side, and two slanted sections down on the very bottom to finish it off. The slanted sections should meet in the middle of the base, and be the same height as the side pieces that we made earlier on.
We also had to add the gold trim in the center of the handle to separate the different colors, and then fill in all the connection points (side to handle trim, handle trim to handle emblem, slanted sections on the back to side trim...etc). We want it to look like one piece of wood. As with the rest, we will put a light coat of filler over the entire trim at the very end of the project.Right now we just want to connect them and fill/sand the gaps to the right height all around.
The final design will look like the picture above (minus the final wood filler layer at the end).
Copyright 2002-2013 Cosplay.com, LLC. All Rights Reserved.
All comments and posts in our forums are the opinion of the respective poster.