Kevin Flynn Identity Disk
Flash Off - Flash On
Made from the top halves of two Rinsler disks (via Amazon) connected together with 6 custom 3D printed boss connector bits.
Replaced the orange "C" rings with clear 3D printed replacements.
Dremeled out the 4 edge notches per side and replaced the rubber edge ring with a "Off/Ring-less" black 3D printed part.
Replaced the original guts with 6 strands of 1.5' 1.2mmDia EL wire (3 per "C" ring), inverter (On/Blink/Strobe) and a hacked Duracell Powerhouse USB battery pack.
Hot glued 4 ND magnets inside to link it to the disk holder.
Copyright 2002-2015 Cosplay.com, LLC. All Rights Reserved.
All comments and posts in our forums are the opinion of the respective poster.