View Single Post
Unread 02-11-2013, 08:57 PM   #2
msleeper
Registered User
 
msleeper's Avatar
 
Join Date: Feb 2013
Posts: 43
Once I had the 3D model sorted out, I created 2D vector templates for the front barrel parts, which were then sent off to the laser cutter. A week or so later, this is what arrived.



Because I needed the parts to take paint and glue, I sanded down all of the surfaces. The laser cut edge also has a distinct pattern from the laser - it's not perfectly straight. So that needed to be sanded down to be level as well.

msleeper is offline   Reply With Quote